Directed Electronics 9400T Benutzerhandbuch

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Automobilelektronik Directed Electronics 9400T herunter. Directed Electronics 9400T 2 Seiten.

Seite drucken

Congratulations on your purchase of the 9400T

back up sensor, designed to aid operation when

going in reverse. Easy installation and simple to

operate, the 9400T back up sensor is notifies the

driver with a series of beeps when the rear of the

vehicle comes close to anything.

Before using the 9400T back up sensor, be sure to

practice and test the product in order to familiar-

ize yourself with the beep indicators and

detection zones as they vary by vehicle.

Sensor Installation

Tools Required

Tape measure

7/8" hole saw

1/16" drill bit

Wire stripper

Electrical tape

Installation

Install the sensor between 1.5 ft. and 2.25 ft.

above the ground level for optimum performance

and mount on the outer edges of the vehicle's rear.

NOTE: Mounting the sensors on the rear tip of the vehicle

is NOT recommended as the sensors may get damaged if

rear ended.

9400T Back Up Sensor

To mount the sensors, mark four equally-spaced

points with the two outer sensors no more than 2.5

ft. apart. See the diagram below for hole sizes.

NOTE: Be sure to check the behind the drill area for

obstructions or reinforcements bars.

It is important not drill the hole larger than the

measurement indicated.

Installation Tips

The sensor should be mounted vertically and

level; mounting on a tilt or unleveled surface will

affect sensor performance.

To avoid false warnings from the sensor be sure

there are no obstructions within a 90 degree

lateral range.

After routing and attaching the cables, use a

small block of wood to press the sensors into

place.

N9400T 3/03