Directed Electronics 9400T Manual del usuario

Navegue en línea o descargue pdf Manual del usuario para Electrónica del automóvil Directed Electronics 9400T. Directed Electronics 9400T 2 páginas.

Congratulations on your purchase of the 9400T
back up sensor, designed to aid operation when
going in reverse. Easy installation and simple to
operate, the 9400T back up sensor is notifies the
driver with a series of beeps when the rear of the
vehicle comes close to anything.
Before using the 9400T back up sensor, be sure to
practice and test the product in order to familiar-
ize yourself with the beep indicators and
detection zones as they vary by vehicle.
Sensor Installation
Tools Required
Tape measure
7/8" hole saw
1/16" drill bit
Wire stripper
Electrical tape
Installation
Install the sensor between 1.5 ft. and 2.25 ft.
above the ground level for optimum performance
and mount on the outer edges of the vehicle's rear.
NOTE: Mounting the sensors on the rear tip of the vehicle
is NOT recommended as the sensors may get damaged if
rear ended.
9400T Back Up Sensor
To mount the sensors, mark four equally-spaced
points with the two outer sensors no more than 2.5
ft. apart. See the diagram below for hole sizes.
NOTE: Be sure to check the behind the drill area for
obstructions or reinforcements bars.
It is important not drill the hole larger than the
measurement indicated.
Installation Tips
The sensor should be mounted vertically and
level; mounting on a tilt or unleveled surface will
affect sensor performance.
To avoid false warnings from the sensor be sure
there are no obstructions within a 90 degree
lateral range.
After routing and attaching the cables, use a
small block of wood to press the sensors into
place.
© 2003 Directed Electronics, Inc.
N9400T 3/03