Clarke CHT637 Betriebs- und Wartungsanleitung - Seite 8
Blättern Sie online oder laden Sie pdf Betriebs- und Wartungsanleitung für Werkzeuge Clarke CHT637 herunter. Clarke CHT637 16 Seiten. Air operated clutch & brake bleeding kit
Seite drucken
5. Connect the Extract Tube (H) to the Fluid
Inlet Plug (G) using the adaptor (E) .
6. Insert the free end of the Extract
Tube (H) into the master cylinder
on the vehicle.
7. Turn the air valve (I) on, if no air
flows through the unit then press
the Push Button (B) to create
the vacuum.
(Allow a few seconds for
vacuum to build in the bleeder
tank before suction occurs).
8. While extracting the old fluid,
agitate the fluid to dislodge and
remove any sludge that has
accumulated on the bottom
and walls of the master cylinder.
9. When all fluid has been removed, turn off the bleeder and refill the master
cylinder with the vehicle manufacturers recommended replacement
hydraulic fluid.
VACUUM BLEEDING HYDRAULIC LINES AND SLAVE CYLINDERS
Prior to bleeding, ensure that the master cylinder is full of the vehicle
manufacturers recommended replacement hydraulic fluid. The automatic
refill unit should be used to maintain the level of new fluid in the master
cylinder during the bleeding process. This will prevent air from being sucked
into the master cylinder, hydraulic lines and slave cylinders.
1. Park the vehicle securely on level ground with the engine off, for safe
access to the brake bleed screws located on each wheel brake cylinder
or to the clutch slave cylinder as required.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
H
B
8
H
E
G
I