clarsen K044 Gebrauchsanweisung Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung Handbuch für Staubsauger clarsen K044 herunter. clarsen K044 10 Seiten. Lightweight carpet cleaner
Seite drucken
Lightweight Carpet Cleaner
Please read and retain these instructions for future reference
Assembly
Note: Do not plug the power cord into an electrical outlet until the machine is fully
assembled.
1. Carefully unpack all components and set aside the packaging.
2. Lift the carpet washer to the upright position.
3. Align the handle with the groove and insert onto body. If necessary, use thumb
and finger pressure to slide handle into position.
4. Once the handle is in place, secure the handle to the body with the two screws
supplied (Fig. 1)
Caution: Do not over tighten. Over tightening could strip the screw holes. Do not
operate the vacuum without the handle screws in place.
CARPET PREPARATION
IMPORTANT: Do not use the carpet washer as a dry vacuum.
1. Vacuum your carpet thoroughly. Ensure it is cleaned before you shampoo.
2. Remove as much furniture from the room as possible. If unable to remove the furniture, place plastic or
foil under and around
HELPFUL HINTS FOR CLEANING CARPET:
1. Use only Low Foaming Cleaning solution with this carpet washer.
2. Do not over saturate the carpet with cleaning solution while using the carpet washer.
3. For heavily soiled areas, additional applications may be necessary.
4. Allow plenty of time to dry the carpet thoroughly.
5. Wipe the cleaning solution from woodwork and furniture to prevent any damage.
6. Try not to walk on the carpet until after the carpet is thoroughly dry, vacuum the carpet using a vacuum
cleaner with a revolving brush bar.
7. Before cleaning, determine where to start and end, making sure not to walk over previously cleaned
areas.
CHECK FOR COLOUR FASTNESS:
Before cleaning the carpet, test for colour fastness. Dampen a white cloth with solution and test a small area
in a closet. Gently rub the cloth over the area. Check each colour for colour bleeding. If the cloth remains
clean, it should be safe to clean the carpet.
AFTER CLEANING:
Allow the carpet to dry completely. Try not to walk on the carpet until it is dry. If it is necessary to walk on
the carpet, place white towels on the areas to be walked on. If the carpet is not dry and the furniture must
be placed back in the room, use plastic or foil under the furniture to prevent staining the carpet. Thoroughly
clean the dirty water tank with warm (max 40ºC) tap water.
Instructions for Use
K044
v001: 21/07/21
Figure 1