clarsen K044 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Aspiradora clarsen K044. clarsen K044 10 páginas. Lightweight carpet cleaner

Lightweight Carpet Cleaner

Please read and retain these instructions for future reference

Assembly

Note: Do not plug the power cord into an electrical outlet until the machine is fully

assembled.

1. Carefully unpack all components and set aside the packaging.

2. Lift the carpet washer to the upright position.

3. Align the handle with the groove and insert onto body. If necessary, use thumb

and finger pressure to slide handle into position.

4. Once the handle is in place, secure the handle to the body with the two screws

supplied (Fig. 1)

Caution: Do not over tighten. Over tightening could strip the screw holes. Do not

operate the vacuum without the handle screws in place.

CARPET PREPARATION

IMPORTANT: Do not use the carpet washer as a dry vacuum.

1. Vacuum your carpet thoroughly. Ensure it is cleaned before you shampoo.

2. Remove as much furniture from the room as possible. If unable to remove the furniture, place plastic or

foil under and around

HELPFUL HINTS FOR CLEANING CARPET:

1. Use only Low Foaming Cleaning solution with this carpet washer.

2. Do not over saturate the carpet with cleaning solution while using the carpet washer.

3. For heavily soiled areas, additional applications may be necessary.

4. Allow plenty of time to dry the carpet thoroughly.

5. Wipe the cleaning solution from woodwork and furniture to prevent any damage.

6. Try not to walk on the carpet until after the carpet is thoroughly dry, vacuum the carpet using a vacuum

cleaner with a revolving brush bar.

7. Before cleaning, determine where to start and end, making sure not to walk over previously cleaned

areas.

CHECK FOR COLOUR FASTNESS:

Before cleaning the carpet, test for colour fastness. Dampen a white cloth with solution and test a small area

in a closet. Gently rub the cloth over the area. Check each colour for colour bleeding. If the cloth remains

clean, it should be safe to clean the carpet.

AFTER CLEANING:

Allow the carpet to dry completely. Try not to walk on the carpet until it is dry. If it is necessary to walk on

the carpet, place white towels on the areas to be walked on. If the carpet is not dry and the furniture must

be placed back in the room, use plastic or foil under the furniture to prevent staining the carpet. Thoroughly

clean the dirty water tank with warm (max 40ºC) tap water.

Instructions for Use

K044

v001: 21/07/21

Figure 1