Clarus ZF-800 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Water Filtration Systems Clarus ZF-800 herunter. Clarus ZF-800 20 Seiten. Treatment systems

Seite drucken

HIBLOW BLOWER TIMER SETTING

To Adjust Clock:

1. Remove 2 Phillips head screws from the grey plastic

top and pull grey top off to access the timer module.

2. To switch to "Time Setting Mode", hold the [HOUR]

button for more than 2 seconds during "Auto" mode.

Adjust with the [HOUR] and [MINUTE] buttons, then

press the [SET] button to set the current time.

To Adjust Backwash Settings:

1. To set "Backwash/Skim Timer Setting Mode", hold

the [SET] button for more than 2 seconds DURING

"Time Setting Mode". Adjust the end time for

backwash with [HOUR] [MINUTE] button. Press

[SET] to set the start time. Adjust the end time with

[HOUR] [MINUTE] button, press [SET] to set 2 second

backwash end time with [HOUR] and [MINUTE]

buttons. Press [SET] to set the 2 second backwash

start time with [HOUR] and [MINUTE] buttons. Press

[SET] twice to set the backwash timer. Make sure

two 5-minute times are set from 2:00 - 2:05 and 3:00 -

3:05.

To Switch Between "Manual" Mode and "Auto" Mode:

1. To switch to "Manual" mode, press [MINUTE] button

for more than 2 seconds. The unit can be switched

between "Recirculation" and "Backwash" with the

[MINUTE] button. Press the [SET] button to switch

back to "Auto" mode.

NOTE: Unit uses a 24-hour clock.

Figure 16

HIBLOW Blower and Timer shown.