Clarus Technologies PCS-25 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Reinigungsgeräte Clarus Technologies PCS-25 herunter. Clarus Technologies PCS-25 14 Seiten. Cleaning stations
Auch für Clarus Technologies PCS-25: Benutzerhandbuch (16 seiten)
Seite drucken
Operators of the Clarus Parts Washer must have on hand an MSDS for each type
of solvent that they will be using. The MSDS are available from the solvent supplier.
In some localities it is required by law that appropriate MSDS are on hand whenever
hazardous or flammable material is being processed.
B.
Safety Equipment.
1. Safety Glasses. Operators should wear safety glasses during the operation of the
Parts Washer. The major hazard is the possibility of splashing petroleum-based
fluids into the eye. If petroleum-based fluid is splashed into the eye, severe
damage may occur. First Aid treatment should be initiated immediately. Refer
to MSDS.
2. Protective Gloves. Appropriate protective gloves should be worn whenever there
is a possibility that the fluids being used may come into contact with the hands.
Different types of gloves may be required for differently types of fluids. The
local safety supply source can recommend the appropriate protective gloves.
3. Flammable. For the safety of owners and operators NO SMOKING around or
near this equipment.
V.
QUICK START GUIDE
Please read entire Quick Start Guide before beginning, this will avoid possible start up
problems.
A.
Uncrate Unit
1. Remove outer wrap.
2. Unbolt legs from pallet.
3. Remove Light Bar from packaging.
4. Remove all loose packing.
B.
Install Light Bar
To install the light bar, attach it to the "Light Bar Bracket" located on the
center/backside of the Parts Washer unit. Nuts and bolts have been provided. Before
tightening the bolts, open the tank lid and secure it to the light bar fusible link. Do not
bend the fusible link. Tighten all bolts. Once the light bar is secured, connect the male
plug of the light bar to the female plug labeled "light bar" out of the electrical box.
C.
Establish Work Area
1. Create a properly sized area for the Parts Washer to be located in. This area
should be a level, solid working area with sufficient overhead room for the light
bar. A 110 volt 15 amp circuit should be within 6 feet of this area.
7