BLADEZ ION 150 Verfahren zur Fehlersuche - Seite 6
Blättern Sie online oder laden Sie pdf Verfahren zur Fehlersuche für Scooter BLADEZ ION 150 herunter. BLADEZ ION 150 12 Seiten. Electric power board
Auch für BLADEZ ION 150: Produkt-Handbuch (13 seiten)
Seite drucken
Check Throttle cable
1. Disconnect the throttle cable from the controller and place a flat head screw driver or any metal piece in between the
connectors of the throttle cable (controller side), then push to turn the rear wheel towards the front as shown. If the unit starts
to run with an initial push and will stop when the screw drive is pulled out, then the throttle cable (Part No. 70238) needs to be
replaced. Otherwise, the control board (Part No. 70269) needs to be replaced.
Unplug the throttle female connector from male connector on the Controller Board, place the probes on contacts as shown and with Ω
select from the voltmeter. The meter should read OL (open circuit) when throttle is off and should read ~ 0.5 Ω with the throttle lever
fully depressed. If OL (open circuit) is found when fully depressed, throttle cable or lever is bad.