BLADEZ ION 150 Процедури усунення несправностей - Сторінка 6
Переглянути онлайн або завантажити pdf Процедури усунення несправностей для Скутер BLADEZ ION 150. BLADEZ ION 150 12 сторінок. Electric power board
Також для BLADEZ ION 150: Посібник по продукту (13 сторінок)
Друкувати сторінку
Check Throttle cable
1. Disconnect the throttle cable from the controller and place a flat head screw driver or any metal piece in between the
connectors of the throttle cable (controller side), then push to turn the rear wheel towards the front as shown. If the unit starts
to run with an initial push and will stop when the screw drive is pulled out, then the throttle cable (Part No. 70238) needs to be
replaced. Otherwise, the control board (Part No. 70269) needs to be replaced.
Unplug the throttle female connector from male connector on the Controller Board, place the probes on contacts as shown and with Ω
select from the voltmeter. The meter should read OL (open circuit) when throttle is off and should read ~ 0.5 Ω with the throttle lever
fully depressed. If OL (open circuit) is found when fully depressed, throttle cable or lever is bad.