3D Hobby Shop SLICK 540 Montageanleitung - Seite 8

Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug 3D Hobby Shop SLICK 540 herunter. 3D Hobby Shop SLICK 540 19 Seiten.

Locate the carbon wing-spar tube. Slide it into the fuselage and slide the wings on as shown. Measure

as shown with a tape measure or yardstick to ensure that the stabilizer is straight. Both sides should

measure exactly the same.

Apply thin CA glue to the joint of the horizontal stabilizer and fuselage. Allow the thin Ca to wick into the

joint. NOTE: It is not necessary to remove any covering on the stabilizer.

Slide the rudder onto the back of the vertical stab, make sure the rudder swings freely 45 degrees as you

did on the elevators and glue the hinges with thin CA glue. Allow to dry.