- ページ 8
おもちゃ 3D Hobby Shop SLICK 540のPDF 組立マニュアルをオンラインで閲覧またはダウンロードできます。3D Hobby Shop SLICK 540 19 ページ。
ページを印刷する7
Locate the carbon wing-spar tube. Slide it into the fuselage and slide the wings on as shown. Measure
as shown with a tape measure or yardstick to ensure that the stabilizer is straight. Both sides should
measure exactly the same.
Apply thin CA glue to the joint of the horizontal stabilizer and fuselage. Allow the thin Ca to wick into the
joint. NOTE: It is not necessary to remove any covering on the stabilizer.
Slide the rudder onto the back of the vertical stab, make sure the rudder swings freely 45 degrees as you
did on the elevators and glue the hinges with thin CA glue. Allow to dry.