AERF EP30 Gebrauchsanweisung

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Fernsteuerung AERF EP30 herunter. AERF EP30 3 Seiten.

Seite drucken

ATTENTION

Dear customer, thank you for having purchased a product from AERF. This

instructions sheet contains important information about the ways of use

and the safety of the installation. Follow the instructions and keep them for

future reference. Radio devices cannot be used in the places that have

factors of influence such as: close to police stations, airports, banks and

hospitals. It is important to carry out a technical control before using radio

system. Only use radio frequency when you do not create problems to the

functioning of the receivers and the emitters. If more than one installation

are functioning in the same frequency, both could be blocked and could not

work properly.

PUSH BUTTONS:

PROG

+ PROG

TO ACTIVATE AND DEACTIVATE THE SUN FUNCTION:

To activate sun function: press

receiver and then sun function will be activated.

To deactivate sun function: press

receiver and then sun function will be deactivated.

BATTERY REPLACEMENT

EP30 is powered by two 3V battery CR 2032 type. To replace the battery open the low lid of the emitter EP30 and extract the exhausted

battery replacing it by a new one. Replace the lid to its initial position.

Attention there is danger of explosion if the battery is replaced with an wrong type of battery. Make sure that you dispose

of old batteries into suitable container.

All the products and the specific skills quoted in this document are submitted to changes without previous notice.

Except personal authorizations and specific cases previously reconciled by AERF, the device has to be used exclusively with AERF receivers.

AERF can not be considered to be in charge of possible damages caused by improper, erroneous use or unreasonable cases.

EP30

EP30 Instruction Manual

- To enter programming mode.

- To select previous channel.

- To select next channel.

- UP.

- DOWN.

- STOP.

- To activate and deactivate the sun function.

(whenever it has a sun captor)

- Transmitters configuration.

and

during 4 seconds until the sun icon

and

during 2 second until the sun icon

PROG

www.aerf.eu

turns on. The remote control will emit an order to the

turns off. The remote control will emit an order to the

EP30

1 - 3