3D R DIY QUAD Montageanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Montageanleitung für Quadcopter 3D R DIY QUAD herunter. 3D R DIY QUAD 12 Seiten.

Seite drucken

C ONT E NTS

30 mm threaded spacers (4)

18 mm threaded spacers (12)

8 mm threaded spacers (4 plus 4 spare)

5 mm steel bolts (8 plus 2 spare)

5 mm nylon bolts (28 plus 4 spare)

Metal nuts (16)

Nylon nuts (8 plus 8 spare)

Metal lock washers (8)

Rubber washers (4)

Zip ties (8)

Motor collets (4)

Double-adhesive

mounting foam

Heat shrink tubing

Deans connectors - male (4)

Five-wire RC receiver cable

Two-wire RC receiver cable

Threadlocking compound

You will also need:

» Phillips screwdriver (small)

» 5.5 mm (7/32) wrench

» Double-sided foam mounting tape

30 mm steel bolts (4)

25 mm steel bolts (12)

850 kV motors with

bullet connectors (4)

10 x 4.7 SFP (pusher) propellers (2)

10 x 4.7 SF (normal) propellers (2)

» 2 mm (5/64) hex wrench

» Soldering equipment

Your 3DR Quad Kit contains:

Bottom plate

APM plate

Electronic speed

controllers (4)

Black arm (3)

Blue arm (2)

Battery strap

XT60 connector - male

Top plate

Landing gear

pieces (8)

Accessory

plate

Power distribution board

Power module with XT60

connectors

These instructions require some minor

soldering. If you're unfamiliar with

soldering, our friends at Sparkfun have

some great tutorials that can get you

started, including this comic:

learn.sparkfun.com/curriculum/42.

For an example of exactly what you'll

be doing for this assembly (soldering

Deans connectors to ESCs), check out

this video: youtu.be/3LJIQeKuLLU.

6-position power

module cable