3D R DIY QUAD Instrukcja montażu - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Quadcoptery 3D R DIY QUAD. 3D R DIY QUAD 12 stron.
Drukuj stronęC ONT E NTS
30 mm threaded spacers (4)
18 mm threaded spacers (12)
8 mm threaded spacers (4 plus 4 spare)
5 mm steel bolts (8 plus 2 spare)
5 mm nylon bolts (28 plus 4 spare)
Metal nuts (16)
Nylon nuts (8 plus 8 spare)
Metal lock washers (8)
Rubber washers (4)
Zip ties (8)
Motor collets (4)
Double-adhesive
mounting foam
Heat shrink tubing
Deans connectors - male (4)
Five-wire RC receiver cable
Two-wire RC receiver cable
Threadlocking compound
You will also need:
» Phillips screwdriver (small)
» 5.5 mm (7/32) wrench
» Double-sided foam mounting tape
30 mm steel bolts (4)
25 mm steel bolts (12)
850 kV motors with
bullet connectors (4)
10 x 4.7 SFP (pusher) propellers (2)
10 x 4.7 SF (normal) propellers (2)
» 2 mm (5/64) hex wrench
» Soldering equipment
Your 3DR Quad Kit contains:
Bottom plate
APM plate
Electronic speed
controllers (4)
Black arm (3)
Blue arm (2)
Battery strap
XT60 connector - male
Top plate
Landing gear
pieces (8)
Accessory
plate
Power distribution board
Power module with XT60
connectors
These instructions require some minor
soldering. If you're unfamiliar with
soldering, our friends at Sparkfun have
some great tutorials that can get you
started, including this comic:
learn.sparkfun.com/curriculum/42.
For an example of exactly what you'll
be doing for this assembly (soldering
Deans connectors to ESCs), check out
this video: youtu.be/3LJIQeKuLLU.
6-position power
module cable
1