3D Robotics IRIS Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Drohnen 3D Robotics IRIS herunter. 3D Robotics IRIS 5 Seiten. Tarot gimbal
Seite drucken3
Place the blue face plate over the camera, and secure
from the back with the two original screws.
Add face plate.
3 Connect
Follow these instructions to connect the gimbal to IRIS. This will allow you to control the tilt
of the camera in flight using your RC transmitter. To enable automatic camera stabilization
without RC control, skip to the step 3: power.
1
Locate the orange, red, and brown three-wire cable protruding
from the bottom of IRIS.
2
Thread the cables through the interface plate. Locate the pins on the Tarot
board. Connect the brown wire to a - (ground) pin and the orange wire to the T
(tilt) pin. Do not connect the red wire.
Thread cables here
tighten
attach orange wire to tilt (T)
attach brown wire to ground (-)