3D Robotics IRIS Manuel - Sayfa 3
Dronlar 3D Robotics IRIS için çevrimiçi göz atın veya pdf Manuel indirin. 3D Robotics IRIS 5 sayfaları. Tarot gimbal
Sayfayı Yazdır3
Place the blue face plate over the camera, and secure
from the back with the two original screws.
Add face plate.
3 Connect
Follow these instructions to connect the gimbal to IRIS. This will allow you to control the tilt
of the camera in flight using your RC transmitter. To enable automatic camera stabilization
without RC control, skip to the step 3: power.
1
Locate the orange, red, and brown three-wire cable protruding
from the bottom of IRIS.
2
Thread the cables through the interface plate. Locate the pins on the Tarot
board. Connect the brown wire to a - (ground) pin and the orange wire to the T
(tilt) pin. Do not connect the red wire.
Thread cables here
tighten
attach orange wire to tilt (T)
attach brown wire to ground (-)