3D Systems Cubify CUBEX Duo Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch für 3D-Drucker 3D Systems Cubify CUBEX Duo herunter. 3D Systems Cubify CUBEX Duo 10 Seiten. Replacing a main board pcb
Auch für 3D Systems Cubify CUBEX Duo: Ersatz-Handbuch (13 seiten), Ersatz-Handbuch (17 seiten), Handbuch (10 seiten)
Seite drucken
Hold the other end of the multimeter against the ground point.
The multimeter screen will give you your voltage reading.
TP X should read 1.3VDC
TP Y should read 1.6VDC
TP Z should read 1.3VDC
TP E1, E2 and E3 should read 1.1VDC
If your voltage is not correct use the small screwdriver to turn the screwhead in very
small increments measuring the voltage between each turn until it is correct.
Unplug your CubeX from mains power.
Re attaching the floor panel and case.
Cut the cable tie holding the floor panel in place and gently lower it down.
8