3DGence DOUBLE P255 Wartungshandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Wartungshandbuch für 3D-Drucker 3DGence DOUBLE P255 herunter. 3DGence DOUBLE P255 19 Seiten.

6. GEAR BELT TENSION MEASUREMENT

Recommended

frequency: every six months or every 2000 h

Once every six months or every 2000 hours it is recommended to review the technical condition of toothed belts

consisting in visual assessment of the degree of wear of the belts and checking their tension.

Before proceeding to check the tension of the toothed belts, you should obtain:

- Belt Tension Tester BTT Hz (Fig. 67).

Fig.67 Belt Tension Tester BTT HZ

Procedure of the measurement of the tension timing belts.

1. Run the belt tension tester (Fig.68).

Fig. 68 Start tester

2. Move the carriage of the module to the maximum left side.

Measurement of the tension timing belts on the axis X

•

Start the tester.

•

Place the microphone facing the toothed belt side at the third black mounting hole of the linear guide

counting from the right side of the printer.

3DGence DOUBLE P255 - maintenance activities | version 07.2021