3DGence DOUBLE P255 유지 관리 매뉴얼 - 페이지 13

{카테고리_이름} 3DGence DOUBLE P255에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DGence DOUBLE P255 19 페이지.

페이지 인쇄
3DGence DOUBLE P255 유지 관리 매뉴얼

6. GEAR BELT TENSION MEASUREMENT

Recommended
frequency: every six months or every 2000 h
Once every six months or every 2000 hours it is recommended to review the technical condition of toothed belts
consisting in visual assessment of the degree of wear of the belts and checking their tension.
Before proceeding to check the tension of the toothed belts, you should obtain:
- Belt Tension Tester BTT Hz (Fig. 67).
Fig.67 Belt Tension Tester BTT HZ
Procedure of the measurement of the tension timing belts.
1. Run the belt tension tester (Fig.68).
Fig. 68 Start tester
2. Move the carriage of the module to the maximum left side.
Measurement of the tension timing belts on the axis X
•
Start the tester.
•
Place the microphone facing the toothed belt side at the third black mounting hole of the linear guide
counting from the right side of the printer.
3DGence DOUBLE P255 - maintenance activities | version 07.2021