3DGence DOUBLE P255 유지 관리 매뉴얼 - 페이지 12

{카테고리_이름} 3DGence DOUBLE P255에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DGence DOUBLE P255 19 페이지.

Calibration of XY offsets:

1. Load the model filament (PLA) and support filament (BVOH) by selecting from the printer menu: MATERIALS

→ LOAD MODEL MATERIAL / LOAD SUPPORT MATERIAL and follow the instructions on the display.

2. Print the calibration model in the printer memory by selecting from the printer menu: MENU → ADVANCED

→ MODULE CALIB. → AUTO XY CALIB.

3. After printing the model, select the line on the display on which the model material with the support

material in part X is best covered (fig. 65).

4. Select the CONTINUE button.

5. Select the line on the display on which the model material with the support material in part Y is best covered

(fig. 66).

6. Select the CONTINUE button.

7. Confirm with the SAVE key.

8. Print the calibration model in the printer memory again by selecting from the printer menu: MENU →

ADVANCED → MODULE CALIB. → AUTO XY CALIB. and visually check the offset calibration level:

• if on the middle line the model material coincides with the support material both in the X axis and in the Y axis -

the XY offsets of the dual hotend module are calibrated correctly,

• if the model material does not coincide with the support material both on the X axis and in the Y axis on the middle

line - the XY offsets of the dual hotend module are not calibrated correctly. Calibrate the offsets again in accordance

with points 2 - 7.

3DGence DOUBLE P255 - maintenance activities | version 07.2021

Fig. 65 Automatic offset calibration screen in the X axis

Fig. 66 Automatic offset calibration screen in the Y axis