3DHobbyShop.com Vyper 46" ARF Montageanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug 3DHobbyShop.com Vyper 46" ARF herunter. 3DHobbyShop.com Vyper 46" ARF 19 Seiten.

Seite drucken

Using your hobby knife, remove the covering on the bottom of the rudder over the tailwheel wire slot.

Using the end of a small screwdriver, or a small drill bit, make the necessary hole for the bent-portion of

the tailwheel wire so that the pivot of the tailwheel is exactly in-line with the rudder hinges. Glue the

tailwheel wire into the rudder with thick CA as shown.

Slide the tailwheel pivot plate over the wire and install with two screws as shown. Install the tailwheel and

collar, tighten the collar. NOTE: YOU MUST INSTALL THE WIRE and PIVOT PLATE in the right

location for the rudder to swing freely – the pivot joint of the tailwheel must be in-line with the rudder

hinges. If after you install the tailwheel, the rudder does not swing freely, re-do the tailwheel and ensure

that there is no friction or binding of the rudder.