3DHobbyShop.com Vyper 46" ARF Montageanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug 3DHobbyShop.com Vyper 46" ARF herunter. 3DHobbyShop.com Vyper 46" ARF 19 Seiten.

Seite drucken

Install motor with the longer 3mm screws as shown. Please note that the motor is installed IN FRONT of

the firewall.

NOTE: Your kit contains 4 plastic motor mount spacers. They may be used as shown to space the motor

away from the firewall as needed for cowl clearance. Short motors, such as the Omega 103g1030KH,

Hacker A30-16M, or Torque 2818-T900 require the spacers. Longer motors, such as the Reaper Gr-35,

Torque 2814-T820 do not require the spacers.

Install speed control to fuselage with short velcro strip or zip ties.

The cowl is mounted onto the fuselage with 4 wood screws. These screws go into the small plywood

squares on the front inside of the fuselage. The following procedure is helpful to be sure the wood

screws hit the plywood squares:

Install the canopy hatch (if the canopy hatch is not installed when you fit the cowl, it may be

impossible to fit the canopy hatch after the cowl is installed!).

Tape small strips of paper over the plywood cowl-mounting tabs as shown below. Install the cowl and

align. Use the small pieces of paper as guides to make holes in the cowl and install the wood screws.

Remove the cowl and screws and soak the plywood mounting tabs in thin CA glue. This will strengthen

the mounting tabs.