3DHobbyShop.com Yak 54 Montageanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug 3DHobbyShop.com Yak 54 herunter. 3DHobbyShop.com Yak 54 18 Seiten. 55” arf rc aircraft
Seite drucken6
Locate the carbon wing-spar tube. Slide it into the fuselage tube.
NOTE: Due to the high-performance nature of this airplane, the carbon wing tube must be a snug-fit into
the wing and fuselage. It may be necessary to lubricate your wing tube from time to time. We
recommend the use of non-stick cooking spray as a lubricant.
Locate the horizontal stabilizer. Slide the stabilizer into the fuselage.
Align the stabilizer with the fuselage in all directions. Check the alignment with a ruler, and check to
make sure the stabilizer is level with the wing tube. It may be helpful to temporarily slide the elevators
into their slots (DO NOT GLUE THE ELEVATORS IN YET!) to help check alignment. This alignment will
take some time.
When you are satisfied with your stabilizer position, use thin CA glue to glue the stabilizer into the slot.
The fit between the stabilizer and the fuselage is meant to be a tight fit. If you need to sand or trim the
slot to achieve proper stabilizer alignment, do so, and if the fit is now loose, use Epoxy glue instead of CA
on this joint. Epoxy will fill any gaps better than CA.