Aeritech 3DQ-S1 Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fernsteuerung Aeritech 3DQ-S1 herunter. Aeritech 3DQ-S1 7 Seiten. Flight control system for multi-rotor aircraft
* Please read "Waring" carefully at first
Flight Control
1 Prepare Vehicle
1.1 Flight Control System Description
3DQ-S1 Flight Control System is designed for Multi-Rotor aircraft, it has good handling performance and
stability.
System modules
MCU Board
IMU
BEC
LED
Tunning and Update
Install"3DQ_Flight_Assistant"software,connect PC to BEC board with microUSB cabel.
You can tuning and update firmware according to the software.
Software download: http://www.aeritech-uav.com
1.2 LED Status Instructions
BEC LED Status
Red flash
Green slow flash
Red slow flash
Yellow light always
White slow flash
[1]When Red flash status,please check remote control is opened and battery voltage.
[2]When Yellow light always,please don't move throttle stick until white slow flash.
Preparing
1 Prepare Remote Control
1.1 Supported RC
Our product support "PPM","PWM"and "S-BUS" receiver,You can choose receiver type according
to software. At least 6-channel remote control.
1.2 RC Setting
You need to set the remote in Acro mode.
Then calibrate your remote control by using the software.
Core of system,control all other modules.
Perception aircraft attitude and position.
Prompt the system status with light.
Statu
System error
System is healthy
Low power
Processing the data
Normal flying condition
page 1
Function
Power the system.
RC not calibrated or other error.
You can operate normally.
Power below the threshold.
Motor is accelerating.
you can take off.
User Manual
Note