Aeritech 3DQ-S1 사용자 설명서 - 페이지 3

{카테고리_이름} Aeritech 3DQ-S1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeritech 3DQ-S1 7 페이지. Flight control system for multi-rotor aircraft

페이지 인쇄

* Please read "Waring" carefully at first

Flight Control

1 Prepare Vehicle

1.1 Flight Control System Description

3DQ-S1 Flight Control System is designed for Multi-Rotor aircraft, it has good handling performance and

stability.

System modules

MCU Board

IMU

BEC

LED

Tunning and Update

Install"3DQ_Flight_Assistant"software,connect PC to BEC board with microUSB cabel.

You can tuning and update firmware according to the software.

Software download: http://www.aeritech-uav.com

1.2 LED Status Instructions

BEC LED Status

Red flash

Green slow flash

Red slow flash

Yellow light always

White slow flash

[1]When Red flash status,please check remote control is opened and battery voltage.

[2]When Yellow light always,please don't move throttle stick until white slow flash.

Preparing

1 Prepare Remote Control

1.1 Supported RC

Our product support "PPM","PWM"and "S-BUS" receiver,You can choose receiver type according

to software. At least 6-channel remote control.

1.2 RC Setting

You need to set the remote in Acro mode.

Then calibrate your remote control by using the software.

Core of system,control all other modules.

Perception aircraft attitude and position.

Prompt the system status with light.

Statu

System error

System is healthy

Low power

Processing the data

Normal flying condition

page 1

Function

Power the system.

RC not calibrated or other error.

You can operate normally.

Power below the threshold.

Motor is accelerating.

you can take off.

User Manual

Note