Acoustic Research AWSBT1 Installations- und Betriebshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Redner Acoustic Research AWSBT1 herunter. Acoustic Research AWSBT1 4 Seiten. Portable wireless speaker
Auch für Acoustic Research AWSBT1: Installations- und Betriebshandbuch (2 seiten)
Seite drucken
Powering the Speaker System
Powering the Speaker
There are two options to power your wireless speaker: using the included AC power adapter or
using 6 AA batteries (not included).
AA Batteries
1. Twist the bolts on the bottom of the speaker counter-clockwise to loosen them completely.
shows the status
2. Remove the bottom of the speaker to access the battery compartment.
3. Insert six (6) AA batteries (not included) into the battery compartment, following the polarity
4. Line the bolts on the compartment door up with the holes on either side of the battery
5. Screw the bolts back in and tighten them.
Note:
DO NOT
battery).
not in use for long periods. Always remove old, weak or worn-out batteries promptly and recycle or
dispose of them in accordance with local and national regulations.
Setting Up Bluetooth Wireless
Pairing
Any Bluetooth-enabled device that you wish to stream audio to your speaker system must fi rst
be paired to the speaker. The process is simple, and in most cases the pairing process needs to
be done only once.
To pair your Bluetooth-enabled device with the speaker:
1. Make sure your device's Bluetooth is turned on. See the wireless and/or network settings
2. If the speaker isn't already on, press and hold the
3. Press and hold for 3 seconds the Pair button to enter pairing mode. You will hear 2 beeps
4. Open the Bluetooth settings menu on your device. Select "AWSBT1" from the list of devices
5. A confi rmation screen will appear on your device once the speaker and the device are
6. Turn the volume on your device to at least 3/4 max, then start playing something on the
Note:
the built-in cable
If you notice the sound from the speaker is distorted, turn down your device's volume.
•
You will hear a beep if you turn the speaker's volume up to the maximum.
•
Speaker
(side panel)
120V AC
wall outlet
AC Power
Adapter
diagrams (+ and –).
compartment and place the speaker bottom back on the speaker.
Place the rubber cap in the speaker power input jack when using batteries.
mix batteries with different chemistry types (for example, a zinc battery with an alkaline
DO NOT
mix new and used batteries.
menu on your device to check.
will hear 4 beeps to indicate the speaker is turned on. The indicator light on the front of the
speaker starts fl ashing blue.
to indicate pairing mode is entered. The indicator on the front of the speaker starts blinking
faster.
available (you might have to scan for devices). If your device asks for a password, enter
"0000".
successfully paired. The blue indicator turns solid blue to indicate successful connection.
The speaker is now ready for you to stream audio from your device.
device. Control the speaker volume on the speaker itself, using the +/– buttons on the top
of the speaker.
AC Power Adapter
1.
Insert the small, round plug from the speaker AC
power adapter into the DC IN jack on the side panel
of the speaker.
2. Plug the other end of the speaker AC power
adapter into any standard 120V AC wall outlet.
Note:
The power unit should be plugged in so that it
stays vertical or lies fl at.
DO NOT
leave batteries installed in the product when
button for 3 seconds to turn it on. You