- ページ 2

スピーカー Acoustic Research AWSBT1のPDF 設置および操作マニュアルをオンラインで閲覧またはダウンロードできます。Acoustic Research AWSBT1 4 ページ。 Portable wireless speaker
Acoustic Research AWSBT1 にも：設置および操作マニュアル (2 ページ)

ページを印刷する

Powering the Speaker System

Powering the Speaker

There are two options to power your wireless speaker: using the included AC power adapter or

using 6 AA batteries (not included).

AA Batteries

1. Twist the bolts on the bottom of the speaker counter-clockwise to loosen them completely.

shows the status

2. Remove the bottom of the speaker to access the battery compartment.

3. Insert six (6) AA batteries (not included) into the battery compartment, following the polarity

4. Line the bolts on the compartment door up with the holes on either side of the battery

5. Screw the bolts back in and tighten them.

Note:

DO NOT

battery).

not in use for long periods. Always remove old, weak or worn-out batteries promptly and recycle or

dispose of them in accordance with local and national regulations.

Setting Up Bluetooth Wireless

Pairing

Any Bluetooth-enabled device that you wish to stream audio to your speaker system must ﬁ rst

be paired to the speaker. The process is simple, and in most cases the pairing process needs to

be done only once.

To pair your Bluetooth-enabled device with the speaker:

1. Make sure your device's Bluetooth is turned on. See the wireless and/or network settings

2. If the speaker isn't already on, press and hold the

3. Press and hold for 3 seconds the Pair button to enter pairing mode. You will hear 2 beeps

4. Open the Bluetooth settings menu on your device. Select "AWSBT1" from the list of devices

5. A conﬁ rmation screen will appear on your device once the speaker and the device are

6. Turn the volume on your device to at least 3/4 max, then start playing something on the

Note:

the built-in cable

If you notice the sound from the speaker is distorted, turn down your device's volume.

•

You will hear a beep if you turn the speaker's volume up to the maximum.

•

Speaker

(side panel)

120V AC

wall outlet

AC Power

Adapter

diagrams (+ and –).

compartment and place the speaker bottom back on the speaker.

Place the rubber cap in the speaker power input jack when using batteries.

mix batteries with different chemistry types (for example, a zinc battery with an alkaline

DO NOT

mix new and used batteries.

menu on your device to check.

will hear 4 beeps to indicate the speaker is turned on. The indicator light on the front of the

speaker starts ﬂ ashing blue.

to indicate pairing mode is entered. The indicator on the front of the speaker starts blinking

faster.

available (you might have to scan for devices). If your device asks for a password, enter

"0000".

successfully paired. The blue indicator turns solid blue to indicate successful connection.

The speaker is now ready for you to stream audio from your device.

device. Control the speaker volume on the speaker itself, using the +/– buttons on the top

of the speaker.

AC Power Adapter

Insert the small, round plug from the speaker AC

power adapter into the DC IN jack on the side panel

of the speaker.

2. Plug the other end of the speaker AC power

adapter into any standard 120V AC wall outlet.

Note:

The power unit should be plugged in so that it

stays vertical or lies ﬂ at.

DO NOT

leave batteries installed in the product when

button for 3 seconds to turn it on. You