3DUpFitters Artillery Sidewinder X1 Enclosure Kit Installationshandbuch - Seite 13
Blättern Sie online oder laden Sie pdf Installationshandbuch für 3D-Drucker 3DUpFitters Artillery Sidewinder X1 Enclosure Kit herunter. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 Seiten.
Seite druckenThey've been running like that for years with no clogging and even with no venting of
the power supplies, we've never had a power supply fail either. Obviously, your mileage
may vary, as it depends on a lot of variables such as filament quality and the quality of
the power supply in your printer.
If you're looking for the highest temperature's possible, try turning the bed heater
on for an hour before you print.
The other part of the equation is the printer design. Those printers where the hot end is
at the top of the enclosure make it easier to achieve higher temperatures because the
hot air rises to the top, and the vertical hot end position is fixed. Those printers with
the hot ends at the bottom are always going to have more problems managing
temperature simply because the temperature is more likely to vary as the hot end goes
from the bottom to the top of the enclosure.
If you're looking to achieve a particular temperature with your enclosure, let us know
and we'll give some advice on how to manage, but its really not that hard:
Lower Temperature = More Air Flow
Higher Temperature = Less Air Flow
The optional thermometer will let you know
approximately what temperature it is inside
the enclosure. It attaches to the left side of
the door piece using the same hole as the
top-most corner connector as shown. It
comes with a longer screw to fit through
everything.
Copyright 2020 3DUPfitters LLC
13