3DUpFitters Artillery Sidewinder X1 Enclosure Kit 설치 매뉴얼 - 페이지 13

{카테고리_이름} 3DUpFitters Artillery Sidewinder X1 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 페이지.

페이지 인쇄

They've been running like that for years with no clogging and even with no venting of

the power supplies, we've never had a power supply fail either. Obviously, your mileage

may vary, as it depends on a lot of variables such as ﬁlament quality and the quality of

the power supply in your printer.

If you're looking for the highest temperature's possible, try turning the bed heater

on for an hour before you print.

The other part of the equation is the printer design. Those printers where the hot end is

at the top of the enclosure make it easier to achieve higher temperatures because the

hot air rises to the top, and the vertical hot end position is ﬁxed. Those printers with

the hot ends at the bottom are always going to have more problems managing

temperature simply because the temperature is more likely to vary as the hot end goes

from the bottom to the top of the enclosure.

If you're looking to achieve a particular temperature with your enclosure, let us know

and we'll give some advice on how to manage, but its really not that hard:

Lower Temperature = More Air Flow

Higher Temperature = Less Air Flow

The optional thermometer will let you know

approximately what temperature it is inside

the enclosure. It attaches to the left side of

the door piece using the same hole as the

top-most corner connector as shown. It

comes with a longer screw to ﬁt through

everything.