3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Installationshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationshandbuch für 3D-Drucker 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit herunter. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 Seiten.
Auch für 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Installationshandbuch (16 seiten)

Seite drucken
Assemble Panels

1. The Front Panel


Each of the corners on the enclosure will be held together by the connectors pictured
below. There are only two versions L and R, which can be identified by the letters
stamped on the inside. The opposite connectors are identical, i.e. Bottom Right is the
same as Top Left. In all cases the surface of the connector with the cutout pattern
faces front or back.
The front door is designed so that the latches are on the left. Attach the corner
connectors on the back side of the door frame using the provided cap head 12mm
screws. See the photos below. The top of the connector should be flush with the top
of the acrylic.


There are also smaller connectors at the top and right side when viewed from the front.
Top Left
Bottom Left
Copyright 2021 3DUpfitters
Top Right
Bottom Right
6