3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 сторінок.
Також для 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Посібник з монтажу (16 сторінок)

Друкувати сторінку

Assemble Panels

1. The Front Panel 

Each of the corners on the enclosure will be held together by the connectors pictured

below. There are only two versions L and R, which can be identiﬁed by the letters

stamped on the inside. The opposite connectors are identical, i.e. Bottom Right is the

same as Top Left. In all cases the surface of the connector with the cutout pattern

faces front or back.

The front door is designed so that the latches are on the left. Attach the corner

connectors on the back side of the door frame using the provided cap head 12mm

screws. See the photos below. The top of the connector should be ﬂush with the top

of the acrylic.

There are also smaller connectors at the top and right side when viewed from the front.

Top Left

Bottom Left

Top Right

Bottom Right