3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 сторінок.
Також для 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit: Посібник з монтажу (16 сторінок)

Друкувати сторінку

Don't Panic If You See This! 

If you can't see through the plastic, please

don't panic! What you're seeing is just the

plastic or paper protective covering.

When plastic sheets are manufactured they

are covered by either a paper (brown

colored) or plastic (white) covering to protect

against scratches. Follow the directions

below to remove the cover and discover the

beautiful plastic underneath.

To remove the covering from an acrylic

panel, lay the panel ﬂat on a table. Then peel

up a corner of the covering and CAREFULLY

and SLOWLY pull horizontally to the sheet to

reduce the lateral forces that would bend the

acrylic. This video shows just what to do.  

Type to enter a caption.