3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 설치 매뉴얼 - 페이지 4

{카테고리_이름} 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 페이지.
3DUpFitters Ender 3 V2/CR-6 Enclosure Kit에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)

페이지 인쇄

Don't Panic If You See This! 

If you can't see through the plastic, please

don't panic! What you're seeing is just the

plastic or paper protective covering.

When plastic sheets are manufactured they

are covered by either a paper (brown

colored) or plastic (white) covering to protect

against scratches. Follow the directions

below to remove the cover and discover the

beautiful plastic underneath.

To remove the covering from an acrylic

panel, lay the panel ﬂat on a table. Then peel

up a corner of the covering and CAREFULLY

and SLOWLY pull horizontally to the sheet to

reduce the lateral forces that would bend the

acrylic. This video shows just what to do.  

Type to enter a caption.