ESI ALL-FLEX FLEX3-WHT-V1 Montage- und Betriebsanleitung - Seite 7
Blättern Sie online oder laden Sie pdf Montage- und Betriebsanleitung für Inneneinrichtung ESI ALL-FLEX FLEX3-WHT-V1 herunter. ESI ALL-FLEX FLEX3-WHT-V1 12 Seiten. 3 leg electric table base
Seite drucken
ASSEMBLY
STEP 10
Once the frame is in its final position, attach it to the work surface using the M5x18 screws (16 total required).
• Attach the screws through the mounting tabs on the frame, center leg column, and center leg top
supports, as well as the holes at the ends of the side column top supports.
• Use a power drill with #2 Phillips bit. This is not a hand tool install.
• After attaching the frame, tighten all 12 set screws, as shown below.
STEP 11
Attach the control unit bracket to one of the center
leg top suports.
• Secure the control unit bracket to the frame using
two M6x15 screws and the 4mm Allen key.
• The bracket may be attached on either side of
the center column. (Note that the digital keypad
will be attached on the same side.)
ALL-FLEX
M5x18
Tighten All 12
Set Screws
4mm Allen Key
3 LEG ELECTRIC TABLE BASE
™
M6x15
Control Unit
Bracket
7