ESI ALL-FLEX FLEX3-WHT-V1 조립 및 작동 매뉴얼 - 페이지 7

{카테고리_이름} ESI ALL-FLEX FLEX3-WHT-V1에 대한 조립 및 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ESI ALL-FLEX FLEX3-WHT-V1 12 페이지. 3 leg electric table base

ASSEMBLY

STEP 10

Once the frame is in its final position, attach it to the work surface using the M5x18 screws (16 total required).

• Attach the screws through the mounting tabs on the frame, center leg column, and center leg top

supports, as well as the holes at the ends of the side column top supports.

• Use a power drill with #2 Phillips bit. This is not a hand tool install.

• After attaching the frame, tighten all 12 set screws, as shown below.

STEP 11

Attach the control unit bracket to one of the center

leg top suports.

• Secure the control unit bracket to the frame using

two M6x15 screws and the 4mm Allen key.

• The bracket may be attached on either side of

the center column. (Note that the digital keypad

will be attached on the same side.)

ALL-FLEX

M5x18

Tighten All 12

Set Screws

4mm Allen Key

3 LEG ELECTRIC TABLE BASE

™

M6x15

Control Unit

Bracket