1 BY ONE Audio-Technica AT3600 Gebrauchsanweisung - Seite 11

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Drehscheibe 1 BY ONE Audio-Technica AT3600 herunter. 1 BY ONE Audio-Technica AT3600 14 Seiten. Belt drive turntable with built in speakers

Seite drucken

4. Place the main platter back onto the sub-platter.

5. Using your hands, slowly rotate the platter ten times in the direction of the

arrow.

Cartridge Replacement

1. Before replacement, put the stylus protector back on the stylus to prevent damage

to the stylus during the replacement process.

2. Carefully remove the wire leads from the original cartridge.

3. Loosen the two screws on the headshell that are securing the cartridge and then

remove the original cartridge.

4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely

tighten the screws at this moment.

5. Connect the wire leads to the new cartridge's terminals .The wire lead color codes

are as below:

Wire

Channel

White

Left channel positive (L+)

Black

Left channel negative (L–)

Red

Right channel positive (R+)

Black

Right channel negative (R-)

6. Adjust the cartridge's position to make sure it is precisely aligned on the headshell

so that the stylus will be tracking the grooves in parallel perfectly.

To achieve this, place the included paper cartridge alignment protractor over the

turntable spindle, carefully lift the tone arm and place the tip of the stylus on the

points marked 130mm and 250mm respectively. Fine tune the cartridge's position

on the headshell until the cartridge is perfectly in parallel with the reference lines at

both points.

7. Tighten the screws completely once the perfect alignment is achieved.

NOTE: If you are unfamiliar or uncomfortable with completing this procedure, we

recommend consulting with a professional to perform the installation.

When the Turntable is Moved

Using the product's original packing materials, wrap the turntable in the reverse order

from when you unwrapped it. If you do not have the packaging materials, take the

following measures:

• After disconnecting the AC adapter from the outlet, remove the felt mat and platter,

and then wrap them so that they do not get damaged.

• Attach the protector to the cartridge.

• Use a string or something similar to tie the tonearm to the rest so that it does not

become dislodged.

• Wrap the turntable body with paper or a soft cloth so that it does not get damaged.