ClearSpan 104903 Montageanleitung Handbuch - Seite 16

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Gewächshaus-Bausatz ClearSpan 104903 herunter. ClearSpan 104903 19 Seiten. Premium solar star greenhouse

ATTACH THE FLASHING
The metal flashing is used to finish the outside panel
edges. The flashing is shipped in 6' lengths and must be
cut to fit. Consult the Additional Flashing Installation
Photos at the back of these instructions.
Use Tek screws (1 1/2") and neo-bonded washers to
install the flashing.
NOTE: Flashing is installed along the edges of the door
and non-door end panels as identified by dotted lines in
the diagram below.
Greenhouse length
may differ from what
is shown.
ATTENTION: Before installing the flashing, remove the
screws holding the polycarbonate panels to the panel
frames. See the dashed lines above.
Remove and
Reinstall Tek Screws
White dashed line shows the edge of the flashing under
the polycarbonate of the roof panel.
Visit www.ClearSpan.com for additional products and customer assistance.
Flashing
Tek screws and washers are reinstalled
through the flashing to secure it to the
greenhouse.
Complete these steps to install the flashing.
1. To install the flashing, begin at one of the lower front
corners and work to the other lower corner of the
same end.
Photo shows installing the first section of flashing.
Greenhouse may be a similar model.
2. Cut the flashing edge to allow it to bend at the
correct angle as it is attached.
ATTENTION: To prevent interference with the hinged
small side panels and solar openers, additional
"trimming" of the flashing is necessary along the edges
of the hinged panels.
3. After attaching the first section, install the next
section and overlap the first section by a few inches.
Flashing will over-
lap the angled end
panels as shown.
15 of 18