ClearSpan 104903 조립 지침 매뉴얼 - 페이지 16

{카테고리_이름} ClearSpan 104903에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan 104903 19 페이지. Premium solar star greenhouse

ATTACH THE FLASHING

The metal flashing is used to finish the outside panel

edges. The flashing is shipped in 6' lengths and must be

cut to fit. Consult the Additional Flashing Installation

Photos at the back of these instructions.

Use Tek screws (1 1/2") and neo-bonded washers to

install the flashing.

NOTE: Flashing is installed along the edges of the door

and non-door end panels as identified by dotted lines in

the diagram below.

Greenhouse length

may differ from what

is shown.

ATTENTION: Before installing the flashing, remove the

screws holding the polycarbonate panels to the panel

frames. See the dashed lines above.

Remove and

Reinstall Tek Screws

White dashed line shows the edge of the flashing under

the polycarbonate of the roof panel.

Visit www.ClearSpan.com for additional products and customer assistance.

Flashing

Tek screws and washers are reinstalled

through the flashing to secure it to the

greenhouse.

Complete these steps to install the flashing.

1. To install the flashing, begin at one of the lower front

corners and work to the other lower corner of the

same end.

Photo shows installing the first section of flashing.

Greenhouse may be a similar model.

2. Cut the flashing edge to allow it to bend at the

correct angle as it is attached.

ATTENTION: To prevent interference with the hinged

small side panels and solar openers, additional

"trimming" of the flashing is necessary along the edges

of the hinged panels.

3. After attaching the first section, install the next

section and overlap the first section by a few inches.

Flashing will over-

lap the angled end

panels as shown.

15 of 18