ClearSpan 104903 조립 지침 매뉴얼 - 페이지 15

{카테고리_이름} ClearSpan 104903에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ClearSpan 104903 19 페이지. Premium solar star greenhouse

53. With the greenhouse assembled, return to the door

and center and adjust it as needed to ensure proper

operation.

54. Using the long Tek screws and neo-bonded

washers, secure the door to the angled end panels.

Angled

End

Panel

Tek screws are installed through the doorframe and into

the square tubes of the angled end panels.

ATTENTION: The screws of the angled end panels that

were removed can be reinstalled. The doorframe of the

door however will serve to secure these panels.

55. After the door is secured, attach the solar-powered

vent openers to each of the vented panels.

NOTE: Consult the directions included with the solar-

powered openers to install these items. Install two (2)

openers for each vented roof panel.

56. After installing the vent openers, read the Foil Tape

and Silicone Sealant information and attach the

greenhouse flashing as described.

Visit www.ClearSpan.com for additional products and customer assistance.

Tek Screw and

Neo-Bonded

Washer

Door

FOIL TAPE AND SILICONE SEALANT

Foil tape and silicone sealant are included with the

greenhouse to seal the spaces between the panels if

desired.

Tape and sealant can be applied from the outside or the

inside depending on the desired results.

For some panels, tape can be applied at the seam

between panels and under the polycarbonate by

removing the screws and washers, installing the tape

under the polycarbonate panels, and reinstalling the

screws.

Tape or sealant can also be applied to the seam that will

be under the flashing when that is installed.

Foil Tape

View above shows foil tape applied over the seam of two

side panels on the inside of the greenhouse.

WARNING: FLASHING IS SHARP! WEAR

GLOVES WHEN HANDLING AND INSTALLING

ALL FLASHING.

14 of 18