ClearSpan 104903 Manual de instruções de montagem - Página 15
Procurar online ou descarregar pdf Manual de instruções de montagem para Kit de estufa ClearSpan 104903. ClearSpan 104903 19 páginas. Premium solar star greenhouse
Imprimir página53. With the greenhouse assembled, return to the door
and center and adjust it as needed to ensure proper
operation.
54. Using the long Tek screws and neo-bonded
washers, secure the door to the angled end panels.
Angled
End
Panel
Tek screws are installed through the doorframe and into
the square tubes of the angled end panels.
ATTENTION: The screws of the angled end panels that
were removed can be reinstalled. The doorframe of the
door however will serve to secure these panels.
55. After the door is secured, attach the solar-powered
vent openers to each of the vented panels.
NOTE: Consult the directions included with the solar-
powered openers to install these items. Install two (2)
openers for each vented roof panel.
56. After installing the vent openers, read the Foil Tape
and Silicone Sealant information and attach the
greenhouse flashing as described.
Visit www.ClearSpan.com for additional products and customer assistance.
Tek Screw and
Neo-Bonded
Washer
Door
FOIL TAPE AND SILICONE SEALANT
Foil tape and silicone sealant are included with the
greenhouse to seal the spaces between the panels if
desired.
Tape and sealant can be applied from the outside or the
inside depending on the desired results.
For some panels, tape can be applied at the seam
between panels and under the polycarbonate by
removing the screws and washers, installing the tape
under the polycarbonate panels, and reinstalling the
screws.
Tape or sealant can also be applied to the seam that will
be under the flashing when that is installed.
Foil Tape
View above shows foil tape applied over the seam of two
side panels on the inside of the greenhouse.
WARNING: FLASHING IS SHARP! WEAR
GLOVES WHEN HANDLING AND INSTALLING
ALL FLASHING.
14 of 18