ClearWater CTA5 Einbauanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Einbauanleitung für Sanitärprodukt ClearWater CTA5 herunter. ClearWater CTA5 3 Seiten. Crystal single lever bath filler, crystal single shroud

Seite drucken

INSTALLATION INSTRUCTIONS

Crystal single Shroud -

Important

Installation

2.5mm

ALLEN

KEY

M5X4mm

GRUB

SCREW

2.5mm

ALLEN

KEY

HOT INLET

1. Before installation, please flush the water system to ensure that no metal swarf, solder, and other impurities can enter the product.

2. Turn off water supply before commencing work, this should be done at the isolating valves of inlet feeds if fitted or main stopcock.

3. Build up water inlet pipe from ground.

4. Take away the washer and fixing nut before you install the bath tap on the standing tube.

5. Screw off the cover nut from standing tube.

6. Screw on the cover nut on the bath tap tail (no supplied). Then screw on the copper tubes (no supplied) also.

7. Slide the copper tubes into the standing tube and tighten the cover nut. Ensure that whilst installing the standing tube, the bath tap

is facing the correct direction.

8. Place the standing tube center of inlet pipe, and mark holes as per the bottom plate, drill and insert plug (if it is necessary).

9. Rise the standing tube on the inlet pipe, and fix the copper tubes to the inlet pipe.

10. Fix the standing tube on the floor with the supplied fittings (2 style screw & plug supplied, one is for Brick/Breezeblock floor,

the other is for wooden floor), finally put on the caps.

Maintenance

We do NOT recommend you use any household cleaners to clean the product. Because these cleaners change substance or formula

too frequently. The product should be always cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.

W24

BATH TAP TAIL (no supplied)

COPPER TUBE (no supplied)

COVER NUT

STANDING TUBE

CAP

CONNECTOR

INLET PIPE (no supplied)

COLD INLET

Dimension

SCREW

PLUG

1 - 1

Ø55

M34X1.5

Ø100

Ø130