djm direct DJMSS406 Betriebshandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Säge djm direct DJMSS406 herunter. djm direct DJMSS406 19 Seiten. Scroll saw
Seite drucken
14. Lubrication
Lubricate the saw arm bearings every 50 hours.
Proceed as above figure shown.
Turn the saw to the side.
Apply a generous amount of SAE 20 oil to the
shaft end and bronze bearings.
Let the lubricant oil work in overnight.
Repeat the procedure the next day on the other
side of the saw.
Carbon Brushes Inspection
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Danger! The carbon brushes should
not be replaced by anyone but a
qualified electrician.
15. Transport
1. Be sure turn off the power and pull out the plug
after use.
2. Pull down the transparent blade guard to
prevent hand cutting during transportation.
3. Disconnect the vacuum cleaner and the other
connecting devices, and remove the connection
bolts between the machine and the work table.
4. Hold the upper end of the U-shaped arm with
one hand while moving; If the saw-blade adapter
& allen wrench (Optional Feature #1) is on the top
of the U-shaped arm, you can move it with both
hands.
5. Raw materials or precision-cut semi-finished
products are recommended to be removed from
the worktable before moving, which may damage
the saw blade and its fixing device.
16. Maintenance
Servicing
Pull the mains plug before any adjustments,
maintenance or repair.
Have any work on the device that is not described in
this instruction guide performed by a professional.
Only use original parts. Allow the device to cool off
before any maintenance or cleaning is undertaken.
There is a risk of burning!
Always check the device before using it for obvious
defects such as loose, worn or damaged parts, correct
the positioning of screws or other parts. Exchange the
damaged parts.
The ball bearings in the spindle and the V-belt pulley
assembly are greased and permanently sealed. Pull the
spindle down and oil the spindle sleeve moderately
every three months.
Lubricate the table bracket and locking knobs if they
become difficult to use.
Cleaning
Do not use any cleaning agents or solvents. Chemical
substances can etch the plastic parts of the device.
Never clean the device under running water.
• Thoroughly clean the device after every use.
• Clean the ventilation openings and the surface of
the device with a soft brush or cloth.
• Remove chips, dust and dirt with a vacuum cleaner
if necessary.
• Lubricate moving parts regularly.
• Vacuum sawdust or metal shavings that accumulate
in and on the motor, pulley housing, table, and work
surface.
• Apply a light coat of paste wax to the column and
table to help keep these surfaces clean and rust-free.
• Do not allow lubricants to come into contact with
switches, V-belts, pulleys and drill lifting arms.
11