Alumax ProLine PL60 Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Gehege Alumax ProLine PL60 herunter. Alumax ProLine PL60 9 Seiten. Heavy frameless bypass bath enclosure

Seite drucken

Notes:

This is a two person installation.

All marks made on tile, marble or fiberglass should be made lightly in

pencil so they can be removed after the installation is complete. An

optional method is to use masking tape on the walls and sill that can be

removed as the installation progresses.

Establish Centerlines – The centerlines of the unit must be estab-

lished on the shower sill and on the walls as well. Measure the width

of the shower sill and mark the centerline down the middle. Transfer the

centerline to the walls using a level. Mark Header Bar location at 3 1/8"

less than the unit height, on the centerline. Measure, and write down,

the distance between the two Wall Mount marks.

Bar Mount – Drill the Wall Mount holes 5/16". Insert the Wall An-

chors [A] fully into the holes. Place the Wall Mount Blocks [B] against

the wall with the counter bore to the middle of the enclosure. Using the

1/4 x 2" Truss head screws [C], attach the Wall Mount Block to the wall,

with the slot in a vertical position and the screw centered in the block.

Bar Length - Measure the width of the fixed glass panel [F]. Subtract

2 3/8" from that dimension. Measure from the center of the middle

hole in the bar to the fixed panel end of the bar and cut that end off

(The fixed panel end is the one with the second hole in it). Now

subtract 1 3/4" from the measurement taken in step 1, which is

the overall width of the shower opening at the top. Then take

that measure from the newly cut end of the bar to the uncut end

and cut that end off of the bar.

Level the Bar – Temporarily place the Wall Mount Sleeves [E] on

each end of the Header Bar. Align the Header Bar with the Wall

Mount Block, and slide the Wall Mount Sleeves over the Wall Mount

Blocks. Place a level on the center of the Header Bar and check for

level. If needed the Wall Mount Blocks can be raised, or lowered to

make the Header Bar level. Once leveled, remove the Header Bar from

the Wall Mount Blocks, and the Wall Mount Sleeves from the Header

Bar. NOTE: A slight downward tilt on the door side of the Header Bar

will help keep the door in the closed position while in use. A downward

tilt on the Fixed Panel side will cause the door to open, allowing water

leakage.

Page 5 of 9