Alumax ProLine PL60 Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Gehege Alumax ProLine PL60 herunter. Alumax ProLine PL60 9 Seiten. Heavy frameless bypass bath enclosure

Seite drucken

Fixed Panel Glass Clips – Mark the center point of the sill, along the

centerline, established in step one. Make a mark 1/2" over toward

the Fixed Panel [F] side and 1" outside of the centerline. Make another

mark 2" over from the wall and 1" outside of the centerline. Drill a 1/4"

hole at each of these marks. Clean the area around the holes and put

a little silicone into each hole. Press the Clip Anchors [G] into the hole

until fully seated. Mount the Glass Clips [I] with the Glass Clip screws

[J]. Install the Vinyl [K] into the Glass Clips.

Center Guide – At the middle of the centerline, make a mark ap-

proximately 2" long and 1 1/16" to the inside of the enclosure. Place

the Center Guide [L] on the new mark, centered on the middle of the

centerline. Mark the center of the attachment holes and, remove the

Center Guide. Drill two 5/16" holes at the marked locations. Clean the

area around the holes and put a little silicone into each hole. Press the

Center Guide Anchors [M] into the holes. Mount the Center Guide with

the Center Guide Screws [O].

Page 6 of 9