Alumax STIKSTALL 795 Series Installationsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Gehege Alumax STIKSTALL 795 Series herunter. Alumax STIKSTALL 795 Series 10 Seiten. Shower enclosure

Seite drucken

- ALL DOORS

Place the two wall jambs [B] into the ends of

the curb [A].

Masking tape may be used to hold

the curb in place during this operation.

both jambs and mark the hole locations on the

walls.

Remove all parts and drill the walls for

mounting hardware.

For tile or marble walls, drill six 3/16" diameter

holes and insert the plastic wall anchors [C].

Attachments to fiberglass or acrylic units can be

made in two ways. If a reinforcement is built into

the wall of the unit, drill six 1/8" holes to install

mounting screws directly into the reinforcement.

If walls are not reinforced, drill six 3/16" holes and

install plastic wall anchors or toggle bolts (toggle

bolts not supplied by Alumax).

- ALL DOORS

Wipe the shower walls and sill, curb [A] and

wall jambs [B] with a clean, dry cloth to remove

any dust or debris.

along the inside of both of the pencil lines marked

in Step #2. Carefully replace the curb in the exact

position marked.

Caulk the inside of the curb

ends where they meet the wall.

Replace both wall jambs and attach to the walls

with six #8 x 1 1/2" truss head screws [D].

- ALL DOORS

Place the setting blocks [E] in the curb [A] as

shown to support the two fixed glass panels [F].

The

setting

blocks

approximately 3" from each corner of the glass

panel.

Remove any protective strips from the first

glass panel and set it into place on the setting

blocks and approximately 1/2" into the wall jamb

[B].

A strip of masking tape 1/2" from each

vertical edge of the glass will aid alignment. Repeat

for the second panel.

NOTE:

Obscure glass panels should be installed

with the rough surface of the glass to the exterior

of the unit.

Deco or etched glass panels should

have the patterned surface to the inside.

Press a 180° post [G] into the curb and position it

to overlap the first glass panel by 1/2".

masking tape to hold the post in position

temporarily.

Repeat for the second post and panel.

NOTE:

To facilitate out of plumb walls, the 1/2"

glass bite may be varied from 1/4" to 3/4".

Apply a 1/4" bead of caulk

should

positioned

Plumb

Use

Page 5 of 10

EPH-N00-06020

1-26-00