Alumax STIKSTALL 795 Series Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Gehege Alumax STIKSTALL 795 Series herunter. Alumax STIKSTALL 795 Series 10 Seiten. Shower enclosure

Seite drucken

- ALL DOORS

Measure the wall-to-wall opening at the top

of the wall jambs [B] and cut the header [H] to fit

the exact opening. Using a 3/16" drill bit, drill the

interior face of the header on both ends as shown.

- ALL DOORS

Press the header [H] over the wall jambs [B]

and the two 180° posts [G].

moving them laterally as required to maintain

proper coverage on the fixed glass panels [F]. The

minimum horizontal dimension for the door

opening is the door panel width (see the graphic in

Step #8) plus 1/2", maximum is the door panel

width plus 1 3/4".

Using the holes in the ends of

the header and curb as a guide, drill four 1/8" holes

into the wall jambs.

header and curb into each 180° post as shown,

then enlarge the four outer holes with a 3/16" drill

for clearance on the self-tapping screws.

the header and curb to the wall jambs and 180°

posts with eight #8 x 1/4" truss head screws [J].

CAUTION:

Slide the glass panels away from the

wall jamb before drilling to prevent breakage.

- 790 DOORS ONLY

Strip two clear vinyl jamb seals [K] into the

door panel [L] splash guard and the pivot jamb

[M] and trim flush at the ends. Both vinyls should

be turned to trap water from the shower head.

Secure the vinyls with a small quantity of glue or

caulk at each end or by carefully crimping the

vinyl pocket.

Set the door panel aside.

Press the pivot jamb and strike jamb [N] (with

magnetic strip) over the two 180° posts [G]. Refer

to Step #1 for the proper handing of the door.

NOTE:

The magnetic strip on the strike jamb

must face the exterior and the clear vinyl jamb

seal on the pivot jamb must face inward.

EPH-N00-06020

1-26-00

Plumb the posts,

Drill two 1/8" holes thru the

Secure

Page 6 of 10