Cutler-Hammer Flex Shaft Schnellstart-Handbuch

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Industrielle Ausrüstung Cutler-Hammer Flex Shaft herunter. Cutler-Hammer Flex Shaft 8 Seiten.

Seite drucken

Cutler-Hammer

Instructions for Drilling and Assembling Flex Shaft

L, M, MDL, N, and R-Frame Series C Circuit Breakers, Molded Case

Switches, and HMCP's

DO NOT ATTEMPT TO INSTALL OR PERFORM

MAINTENANCE ON EQUIPMENT WHILE IT IS ENER-

GIZED. SEVERE PERSONAL INJURY, DEATH, OR

SUBSTANTIAL PROPERTY DAMAGE CAN RESULT

FROM CONTACT WITH ENERGIZED EQUIPMENT.

ALWAYS VERIFY THAT NO VOLTAGE IS PRESENT

BEFORE PROCEEDING WITH THE TASK, AND

ALWAYS FOLLOW GENERALLY ACCEPTED

SAFETY PROCEDURES.

CUTLER-HAMMER IS NOT LIABLE FOR THE

MISAPPLICATION OR MISINSTALLATION OF ITS

PRODUCTS.

The user is cautioned to observe all recommendations,

warnings and cautions relating to the safety of person-

nel and equipment as well as all general local health

and safety laws, codes and procedures.

The recommendations and information contained herein

are based on Cutler-Hammer's experience and judg-

ment, but should not be considered to be all-inclusive or

covering every application or circumstance which may

arise. If any questions arise, contact Cutler-Hammer for

further information or instructions.

Figure 1-1 Pivot Bracket and Outer Handle Mechanism Assembly

Effective February 2001 Supersedes I.L. 15606B dated October 1997

WARNING

Handle Mechanism for

GENERAL INFORMATION

The Shaft handle mechanism provides a means of exter-

nally operating the circuit breaker and can be applied to

enclosures of varying heights and depths. The handle

can be used with NEMA 1, 3R, and 12 enclosure applica-

tions, plus NEMA 4 and 4x applications, depending on

the accessory components selected. An operating han-

dle, flexible shaft, and mechanism are required for stan-

dard applcation. Three lengths of shafts are available for

use with the range of depths of various enclosures (4', 5',

and 6'). When selecting the length of the Flexible Shaft,

ensure Minimum Bending Radius of 5 inches is main-

tained to operate properly. The flex shaft assembly is

Underwriters Laboratories, Inc. listed under UL File

E64983.

WHEN INSTALLING A NEW HANDLE MECHANISM,

OR A NEW CIRCUIT BREAKER AND HANDLE

MECHANISM IN AN EXISTING ELECTRICAL SYS-

TEM, MAKE SURE THERE IS NO VOLTAGE PRE-

SENT WHERE WORK IS TO BE PERFORMED. SPE-

CIAL ATTENTION SHOULD BE PAID TO REVERSE

FEED APPLICATIONS TO ENSURE NO VOLTAGE IS

PRESENT. THE VOLTAGE IN ENERGIZED EQUIP-

MENT CAN CAUSE DEATH OR SEVERE PERSONAL

INJURY.

I.L. 15606C

File 29-000

WARNING