ALUZ ZIBI A1 Series Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Beleuchtungsanlagen ALUZ ZIBI A1 Series herunter. ALUZ ZIBI A1 Series 11 Seiten. Surface zuco pivot bios illuminated
Auch für ALUZ ZIBI A1 Series: Installationsanleitung Handbuch (12 seiten), Handbuch (11 seiten), Handbuch (13 seiten), Installationsanleitung Handbuch (11 seiten)

Seite drucken
Note: Assemble the parts per the diagrams below. Feed power lead
through each part into a junction box (by others) for the powered arm.
1
Measure area where luminaire will be installed. Use a laser line to
create a reference line along installation area, ensuring consistent
alignment of mounting arms. Mark location where each mounting
arm will be installed along reference line.
2
Mark location where each mounting arm will be installed. Install an
outdoor rated 4" octagonal j-box (by others) at each location that
requires a power lead. The cover plate mounts directly to the j-box.
Cover plates without a j-box must be mounted by other means.
-
(
)
3
Screw the Rods into the Cover Plates by turning clockwise.
4
Place Pivot Cap on the end of luminaire and secure with set screw.
Repeat process for the other end of luminaire.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZUCO Pivot BIOS Illuminated
(A1-ZUCO-PVT-BIOS)
-
(
)
866.ALUZ.LTG | 714.535.7900
5
Place Pivot Head onto Pivot Cap and secure with blue tape to hold
in place. Repeat process for the other end of luminaire.
6
Mount the unpowered arm to the mounting surface. Only mount
the assembled Plate and Rod. Ensure the part is securely mounted
to a solid surface such as wood, concrete, or metal. Use mounting
hardware (by others) appropriate for the surface material and
weight of the luminaire.
Note: Steps 7 and 8 require two or more people to complete.
7
Feed lead wires through Mounting Arm parts per the assembly
diagram, then make wiring connections inside a j-box (by others).
Once wiring connections are made, push excess wire into j-box and
mount Cover Plate.
Note: Ensure all excess wire is pushed into j-box and no wires are
pinched between assembly parts.
Page 7 of 11
Mounting Arm (1 of 2)
(A1-ZUCO-PVT-EC-AA-X)
&
Installation Instructions
8 / 9 / 2023 / Rev 0