ALUZ ZIBI A1 Series Manual - Page 7

Browse online or download pdf Manual for Lighting Equipment ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 11 pages. Surface zuco pivot bios illuminated
Also for ALUZ ZIBI A1 Series: Installation Instructions Manual (12 pages), Manual (11 pages), Manual (13 pages), Installation Instructions Manual (11 pages)

Print Page
Note: Assemble the parts per the diagrams below. Feed power lead
through each part into a junction box (by others) for the powered arm.
1
Measure area where luminaire will be installed. Use a laser line to
create a reference line along installation area, ensuring consistent
alignment of mounting arms. Mark location where each mounting
arm will be installed along reference line.
2
Mark location where each mounting arm will be installed. Install an
outdoor rated 4" octagonal j-box (by others) at each location that
requires a power lead. The cover plate mounts directly to the j-box.
Cover plates without a j-box must be mounted by other means.
-
(
)
3
Screw the Rods into the Cover Plates by turning clockwise.
4
Place Pivot Cap on the end of luminaire and secure with set screw.
Repeat process for the other end of luminaire.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZUCO Pivot BIOS Illuminated
(A1-ZUCO-PVT-BIOS)
-
(
)
866.ALUZ.LTG | 714.535.7900
5
Place Pivot Head onto Pivot Cap and secure with blue tape to hold
in place. Repeat process for the other end of luminaire.
6
Mount the unpowered arm to the mounting surface. Only mount
the assembled Plate and Rod. Ensure the part is securely mounted
to a solid surface such as wood, concrete, or metal. Use mounting
hardware (by others) appropriate for the surface material and
weight of the luminaire.
Note: Steps 7 and 8 require two or more people to complete.
7
Feed lead wires through Mounting Arm parts per the assembly
diagram, then make wiring connections inside a j-box (by others).
Once wiring connections are made, push excess wire into j-box and
mount Cover Plate.
Note: Ensure all excess wire is pushed into j-box and no wires are
pinched between assembly parts.
Page 7 of 11
Mounting Arm (1 of 2)
(A1-ZUCO-PVT-EC-AA-X)
&
Installation Instructions
8 / 9 / 2023 / Rev 0