Alvarez System 600T MK II Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Alvarez System 600T MK II herunter. Alvarez System 600T MK II 4 Seiten. Acoustic preamp / eq
Seite drucken
CONTENTS
Internal Chassis Controls / Connections ..................................2
Diagram of System 600T MK II ..............................................3
Digital Tuner Function..............................................................5
Specifications............................................................................6
CONGRATULATIONS!
You have chosen the finest acoustic
Preamp/Eq System available.
The Alvarez System 600T MK II Preamp/Eq is designed to offer the
finest acoustic guitar tone reproduction available. The System 600T MK
II provides a broad range of sonic control, mixing capability for different
combinations of piezo/magnetic/microphone transducers, and features an
on-board digital chromatic tuner. We recommend that you take a few
minutes to read this manual in order to familiarize yourself with the
many advanced features and capabilities of the System 600T MK II.
This guitar is equipped with a piezo pickup mounted under the bridge
saddle. This pickup is connected to the PIEZO input of the System 600T
MK II, and the guitar will perform perfectly with this pickup/preamp
combination. The System 600T MK II is capable of mixing an additional
Alvarez ACM50 condenser mic or an Alvarez ASP50 MK II sound hole
pickup with the piezo pickup for a wider range of sonic possibilities.
Some features of the System 600T MK II will only operate when an
additional pickup/microphone is used.
1
S Y S T E M 6 0 0 T M K I I OW NE R S G UI DE
INTERNAL CHASSIS
CONTROLS/CONNECTIONS
With the chassis removed from the mounting ring, you will notice
connections on the rear panel, next to the battery compartment. The
connection marked (1) OUTPUT is for the signal being sent to the
output jack. There are two INPUT jacks, labeled (2) PIEZO and
(3) AUX. The PIEZO input should already be connected to the
under-saddle bridge pickup. The AUX input is included for use with an
additional Alvarez ASP50 MK II sound hole pickup or an Alvarez
ACM50 condenser microphone. Power for the ACM50 is supplied
through the ring of the AUX jack.
On the side of the chassis are two trim pots, labeled (4) LOW and
(5) HIGH. These trim pots are used to adjust the gain of the BASS
and TREBLE sliders on the front panel. These
adjustments are used to "fine tune" the System
600T MK II to the sonic characteristics of the
particular guitar being used.
BATTERY
COMPARTMENT
The System 600T MK II is powered by
a 9 Volt battery mounted in the bottom of
the control chassis. Access the battery
compartment by removing the two front panel
thumb screws and lifting the chassis from the
mounting ring. Further, the System 600T
MK II can be phantom powered on
instruments equipped with an optional XLR
switching jack via the 3-pin connector on the
rear of the chassis.
Refer to the front panel diagram on the next page
to familiarize yourself with the various control
functions of the Alvarez System 600T MK II.
6
2
3
5
4
1
5
4
2